Morse code chart
Every letter and number in International Morse. Select any letter, sign or abbreviation to hear it at your speed, 12 words per minute (change it).
No letter is longer than four dots and dashes.
Punctuation
| Full stop | ·−·−·− | |
| Comma | −−··−− | |
| Question mark | ··−−·· | |
| Apostrophe | ·−−−−· | |
| Slash | −··−· | |
| Open bracket | −·−−· | |
| Close bracket | −·−−·− | |
| Colon | −−−··· | |
| Double hyphen (break) | −···− | |
| Plus (end of message) | ·−·−· | |
| Hyphen | −····− | |
| Quotation mark | ·−··−· | |
| At sign | ·−−·−· |
Procedure signals
Prosigns are sent as one character, with no gap between the letters.
| ···−−−··· | Distress signal, sent as one run with no letter gaps. | |
| ·−·−· | End of message. | |
| ···−·− | End of contact. | |
| −···− | Break between parts of a message. | |
| −·−−· | Over to the named station only. | |
| −·− | Over to anyone: go ahead. | |
| ········ | Error: eight dots, then resend the word. |
Common abbreviations
| Calling any station | |
| From, or this is | |
| Received | |
| Thanks | |
| Best regards | |
| My location is | |
| Who is calling me? | |
| I confirm receipt | |
| Signal report: readability, strength, tone |
Numbers
Every digit is five elements. From 1 to 5 the count of dots at the start names the digit; from 6 to 0 the dashes come first, so 6 is a dash and four dots and 0 is five dashes.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 0
Reading the tree
The trainer shows the code as a tree. Start at the arrow at the top. A dot moves you right and a dash moves you left, so a single dot is E and a single dash is T. Every further dot or dash follows a branch down from where you are, and wherever you stop is your letter. Letters near the top are short and common; the four-element letters hang at the bottom.
Timing
Morse is measured in units. A dot is one unit and a dash is three. The gap inside a letter is one unit, the gap between letters is three, and the gap between words is seven.
In the sender stages a short pause ends a letter and a longer one ends a word, measured against your own speed. In Practice you can also end letters and words by hand.
Source: ITU-R M.1677-1- 1 unit
- 3 units
- 3 units
- 7 units